安平县华耀农业设施工程有限公司

       苗床是由苗床网、铝合金边框、滚轴管、横撑、支架、手轮、调节小腿等组装而成，整体结构采用后热镀锌工艺。

       苗床一般常用规格有：1.7米、1.75,米、1.8米、长度可以拼接，孔是30mm*130mm、丝径有3mm+3mm和3mm+4mm的。

移动苗床的安装过程：
1.根据安平县华耀育苗床厂的移动苗床图纸，摆放并固定苗床支架。
2.根据安平县华耀育苗床厂的移动苗床图纸连接端头斜撑。
3.根据安平县华耀育苗床厂的移动苗床图纸摆放滚轴管，并将滚轴管置于苗床支架上。
4.在滚轴管上面摆放横支撑，距离根据移动苗床图纸来定。横支撑的效果是增加苗床工作台的承重能力。
5.在滚轴管上组合苗床工作台，并铺设苗床钢丝网面，铝合金型材作为边框。
6.根据滚轴管的管径苗床安装相应的苗床手轮。
7.安装防侧翻设备避免苗床工作台在移动时发生侧翻。
8.调整滚轴管及工作台，使工作台在中间方位时，随翻滚体的滚动可分别向左或向右移动300mm。
9.挨个调整温室内的苗床。
10.逐一检查每个苗床，并修锉毛刺。
Installation process of mobile seedbed:
1. Put and fix the seedling bed bracket according to the mobile seedling bed drawing of Huayao Seedling bed Factory in Anping County.
2. Connecting end brace according to the mobile seedling bed drawing of Huayao Seedling bed factory in Anping County.
3. According to the mobile seedling bed drawing of Huayao Seedling bed Factory in Anping County, place the roller tube on the seedling bed bracket.
4. Place horizontal support on the roller pipe, and the distance shall be determined according to the drawing of the mobile seedbed. The effect of transverse support is to increase the bearing capacity of the seedbed table.
5. Combine the seedling bed table on the roller tube, and lay the seedling bed wire mesh surface, aluminum alloy profile as the frame.
6. Install the corresponding nursery bed handwheel according to the diameter of the roller pipe.
7. Install anti-rolled-over equipment to avoid rolled-over when the nursery table moves.
8. Adjust the roller tube and the table so that when the table is in the middle direction, it can move 300mm to the left or right with the roll of the tumbling body.
9. Adjust the nursery beds in the greenhouse one by one.
10. Check each seedbed one by one and file burrs.


    安平县华耀育苗床厂生产移动苗床、固定苗床、潮汐苗床等温室育苗设备，并备有的温室喷灌设施，规格尺寸都可定做，并为您提供施工图纸